Parkinson Cowan RG50MGWN User Manual download pdf (Page 34)

INSTALLATION

1. PARTS REQUIRED

The loose hotplate parts and battery are packed in the polystyrene fitment on top of the hotplate.

2. LEVELLING THE APPLIANCE

Adjustable levelling feet at the front and at the rear are provided on the base of the appliance.

Adjustment to suit floor conditions is obtained by rotating in or out the hexagonal feet from the underside of

the appliance.

A spirit level should be placed on one of the oven shelves to confirm that the appliance is correctly levelled.

3. FITTING THE STABILITY BRACKET

It is recommended that if the appliance is to be installed with a flexible supply pipe a stability bracket

(SK.4729.A) is fitted and is available from your supplier (see Important Safety Requirements, Page 31).

These instructions should be read in conjunction with the leaflet packed with the stability bracket.

1. Place the appliance in its intended position and level appliance.

2. Mark off 250mm from the left hand side of the appliance as shown in dimension 'A', Fig 3a. This is the

centre line of the fixing bracket.

3. Draw a line 100mm from the front edge of the levelling feet (see Fig 3a) and remove appliance from its

position. Mark off dimension 'B' (see Fig 3a) back from this line on the centre line of the bracket to locate the

front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure the height

from floor level to engagement edge on back of appliance, dimension 'C' of Fig. 3b.

4. Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' +3mm above floor

level. (see Fig. 3b).

Reposition appliance and check that top bracket engages into appliance back as shown in Fig. 3b.

Fig.3a Fig.3b

R G 5 0 M

487mm (B)

(A)

250mm

100mm

20mm

(C)

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Parkinson Cowan RG50MGWN User Manual Page 34