Parkinson Cowan RG50MGWN User Manual download pdf (Page 35)

4. CONNECTING TO GAS

This appliance is designed to be installed with an appliance flexible

connection only. Supply piping should not be less than R³/8.

Connection is made to the Rc½ (½" B.S.P.) female threaded entry

pipe located just below the hotplate level on the rear left hand side of

the appliance. NOTE: ONLY LIQUID SEALANTS TO BE USED

WHEN INLET GAS PIPE IS FITTED I.E.: DO NOT USE P.T.F.E.

SEALANT TAPE.

Check for gas soundness after connecting the gas supply.

The gas bayonet connector must be fitted in the shaded area

indicated in Fig. 3. Take into account that it must be possible to pull

the appliance forward sufficiently. The hose must not get caught on

the stability bracket.

IMPORTANT: FLEXIBLE TUBING USED MUST COMPLY WITH

BS. 669 CURRENT EDITION.

L.P.G. FLEXIBLE CONNECTIONS MUST BE OF A TYPE

SUITABLE FOR L.P.G. AND CAPABLE OF OPERATION UP TO

50 mbar AND TO CARRY A RED STRIPE, BAND OR LABEL.

5. Fitting the battery

1. The battery is located on the left hand side of the front plinth and can be viewed througha slot in the bottom left hand corner

of the front frame.

2. To gain access to the battery, open the main oven door, rotate the battery holder clockwise.

3. Fit the battery AA size ensuring the positive, + terminal is on the right hand side. Return the battery to original position by

turning it anti-clockwise.

6. PRESSURE TESTING

1 The oven injector is used as a pressure test point.

Remove the oven furniture. Remove oven burner box retaining clips (one spring clip from each side) and

remove box front cover. Replace one clip back into the right hand side of the burner box.

Remove oven burner by removing the spring clip from the right hand side of the oven burner and slide

burner off injector, whilst easing it forward and taking care not to strain the F.S.D. phial.

2. Connect the pressure gauge to the oven injector.

3. Check the supply pressure by turning the thermostat on and one hotplate tap full on and light the

appropriate burner. The pressure should be either:-

(i) For Natural Gas 20mbar

(ii) For LP.Gas The pressure must be set to 28 mbar for use on butane or 37 mbar for use on propane.

4. Turn off the taps, disconnect the pressure gauge and replace oven burner and cover, ensuring that the

F.S.D. phial is correctly located into the bracket on the burner.

5. Check operation of oven.

7. CHECKING THE GRILL

Place the grill pan into the grill compartment. Light the grill burner by turning the grill tap full on and pressing

the ignition button on the fascia panel. As soon as the burner is lit the button can be released.

R G 5 0 M

225

250

400

700

Fig.3

All dimensions in mm

1 2 ... 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

Parkinson Cowan RG50MGWN User Manual Page 35

Comments to this Manuals

Related products and manuals for Cookers Parkinson Cowan RG50MGWN